manan 6th April 2009, 10:10 pm
abhinavgupta wrote:What are the specs of the audio bank.
Even i am unaware of that.
My subs are DVC.
With the JBL whenever i used to increase volume above 25 ( in my alpine) the amp used to lower the power of the subs as if it was going into protection mode or something.
It wasnt tripping but lowering the bass
I used the Fuse Rating to confirm the Specs, When you try to google you dont get information about Audiobank AMPS. Your AMP has 40Ax3=120A Fuses, Considering the JBL 1400.1 which has 40x4=160A Fuses. So Your amp to the max can give 1400 RMS Power of Power but must be giving around 1000W, The JBL has the maximum capacity of 1900W gives around 1500.
Your Previous amp must be going into Protection mode,therefore lowering the output at higher volumes, that can be the only reason or their must be some defect in your AMP.
Did the protection light(If the JBL had one) glow on increasing the volume???
Yours Subs are 4 OHM DVC?? means the total impedence to the Amp is 1 ohms?? how you powering them?? How have they been wired?